wood lamp post designs

72 views

wood-lamp-post-designs wood lamp post designs

wood lamp post designs – In case you have ever ordered rawhide lamp shades or any sort of lampshade for that matter over the telephone or online, you know it can be a challenging task. It can be quite frustrating because different individuals measure lampshades otherwise.

The entire thing is complicated by telephone conversations and net ordering. If you understand how you should measure a shade to obtain the correct fit and communicate the appropriate size, you will avoid problems and receive the lamp colour you are expecting.

It doesn’t matter if the shade is made from rawhide or not, there are a couple of suggestions you should know to accurately measure and order a colour and also terminology that will help you insure that the individual receiving your order is on the same track. We create custom made rawhide lamp shades for rustic western lamps and southwest home decorating. Since we experience this issue constantly we have some hints that we use to insure the appropriate style for a lamp, even without visiting the lamp ourselves.

How to measure:

  1. You will need to have three important measurements, bottom diameter, high diameter and height. The base diameter is the measurement across the base opening of the lamp shade. The top diameter is the distance across the upper opening of this colour. The height of a lampshade ought to be measured up and down vertically, not over the slant. This is where the confusion starts. When communicating the measurements different folks and shops will set the three dimensions in different order, it’s not normal, so be careful that you are not confusing the underside and height measurements such as.
  2. The height ought to be measured down and up, but a few will measure across the slant. Both of these measurements can be quite different and induce the finished shade to be incorrect if perplexed. Always clarify how the height is measured. We’ve found that many men and women who measure the slant of this colour refer to it as the colour’s length instead of height.

Height Measuring Hint:

The reason you need to measure height up and down, vertically, is the height measurement of your lamp out of bulb socket foundation to top of harp is probably the minimum vertical height you will want to pay the electric components with the colour

If you are considering a stock replacement colour, your lamp’s overall height and appearance can be corrected. The wire harp that retains the shade within the bulb is synonymous. That is excellent news if a typical shade is state an inch to brief. Instead of having to order a personalized colour you could alter the harp causing the shade to sit on the lamp to offer you the desired appearance.

A normal shade mount has a centre bar across the top with a pit to the harp bracket or a washer based by three affirms that attach to the upper rim of the colour. Both allow the shade to be secured to the harp. Some smaller lamps and chandeliers don’t use a harp but instead use a bulb clip to attach directly to the bulb. A bulb clip is two wire loops that are attached to the shade’s centre bar and hold the bulb.

An bulb clip adapter could be added to any typical shade to allow it to be put within the bulb. Chandelier lamp shades normally have built-in ribbon clips created for the small flame or candelabra shaped bulbs. Shades used as hanging lamps can use an uno bracket which has a centre ring large enough to get the bulb socket to pass through. These also appear on a few table lamps. It’s possible to use a bulb clip onto a substitute shade rather than an uno bracket.

Consider putting these basic suggestions to work on the following rawhide lamp shade or substitute lampshade project and you will be sure to measure, order and receive the right size lamp colour the first time.

Leave a reply "wood lamp post designs"

Author: 
    author