swag lamps for sale


swag-lamps-for-sale swag lamps for sale

swag lamps for sale – In case you have ever ordered rawhide lamp shades or any sort of lampshade for that matter over the phone or online, you know it can be a challenging undertaking. It can be very frustrating because different people quantify lampshades differently.

The entire thing is complicated by phone conversations and net ordering. If you understand the best way to measure a color to get the proper fit and also communicate the appropriate size, you’ll avoid problems and receive the lamp colour you’re expecting.

It doesn’t matter if the color is made from rawhide or not, there are a few tips you should know to accurately measure and order a colour and also terminology that can allow you to insure that the person receiving your order is on the same track. We produce custom made rawhide lamp shades for rustic western lamps and southwest home decorating. Because we encounter this issue constantly we’ve got some hints that we use to insure the appropriate look for a lamp, even without visiting ourselves.

How to quantify:

  1. You’ll have to have three key measurements, bottom diameter, top diameter and height. The base diameter is the dimension across the base opening of the lamp color. The elevation of a lampshade ought to be measured up and down, not along the slant. This is where the confusion starts. When conveying the measurements different folks and shops will place the three dimensions in different order, it’s not normal, so be careful that you’re not confusing the bottom and height measurements for example.
  2. The height ought to be measured down and up, but some will quantify across the slant. Both of these measurements can be quite different and cause the finished shade to be incorrect if perplexed. Always clarify the method by which the elevation is measured. We have found that lots of people who quantify the slant of this colour refer to it as the colour’s length instead of height.

Height Measuring Hint:

Height Adjustment Tip:

If you’re thinking about a stock replacement colour, your lamp’s overall height and look can be corrected. The cable harp that holds the color over the bulb is interchangeable. This is great news if a typical shade is say an inch to short. Rather than having to order a personalized colour you could change the harp causing the color to sit on the lamp to give you the desired look.

Shade Mounting Type:

A normal color bracket has a centre bar across the top with a pit for the harp mount or a washer centered by three supports that attach to the upper rim of the colour. Both allow the color to be procured to the harp. A bulb clip is simply two wire loops that are attached to the color’s centre bar and hold the bulb.

An bulb clip adapter can be inserted to any typical shade to allow it to be put over the bulb. Chandelier lamp shades normally have built-in ribbon clips made for the little flame or candelabra shaped bulbs. Shades used as hanging lamps can use an uno mount which has a centre ring big enough for the bulb socket to maneuver through. These also appear on some table lamps. It’s possible to use a bulb clip on a replacement shade rather than an uno mount.

Try putting these basic tips to work on your next rawhide lamp color or replacement lampshade project and you’ll make certain to measure, order and receive the right size lamp colour the very first moment.

Leave a reply "swag lamps for sale"