jc penneys lamps – In case you’ve ever ordered rawhide lamp shades or any sort of lampshade for that matter over the phone or on the internet, you are aware that it can be a difficult undertaking. It can be quite frustrating because different individuals quantify lampshades differently.
The entire thing is complicated by phone conversations and internet ordering. If you understand the best way to measure a color to get the proper fit and communicate the appropriate dimensions, you’ll avoid problems and receive the lamp colour you are expecting.
It doesn’t matter if the color is made from rawhide or not, there are a couple of tips you should know to correctly measure and purchase a colour and additionally vocabulary which will allow you to insure that the person receiving your purchase is on the same track. We produce custom made rawhide lamp shades for rustic western lamps and southwest home decorating. Because we encounter this issue all the time we have some hints that we use to insure the appropriate style for a lamp, even without visiting ourselves.
How to quantify:
- You will need to have three key measurements, bottom diameter, top diameter and height. The bottom diameter is the measurement across the bottom opening of the lamp color. The height of a lampshade should be measured straight up and down, not over the slant. This is where the confusion begins. When communicating the measurements different individuals and shops will set the three measurements in different sequence, it’s not normal, so be careful that you are not confusing the bottom and height measurements such as.
- The height should be measured straight down and up, but a few will quantify across the slant. Both of these measurements are often quite different and cause the finished shade to be incorrect if confused. Always clarify how the height is measured. We’ve discovered that many people who quantify the slant of the colour refer to it because the shade’s length instead of height.
Height Measuring Tip:
The reason you need to measure height up and down, vertically, is that the height measurement of your lamp out of bulb socket base to top of harp is probably the minimum vertical height you will want to pay the electrical components with the colour
If you are thinking about a stock replacement colour, your lamp general height and look can be corrected. The cable harp that holds the color within the bulb is synonymous. That is great news if a typical shade is state an inch to short. Rather than having to purchase a custom colour you could change the harp causing the color to sit lower on the lamp to offer you the desired look.
Shade Mounting Type:
A normal color bracket has a center bar across the top with a hole to the harp bracket or a washer based by three supports that attach to the top rim of the colour. Both allow the color to be procured to the harp. A bulb clip is two wire loops which are attached to the shade’s center bar and grip the bulb.
An bulb clip adapter could be added to any typical shade allowing it to be placed within the bulb. Chandelier lamp shades normally have built-in bulb clips made for the small flame or candelabra shaped bulbs. Shades used as hanging lamps may use an uno bracket that includes a center ring big enough for the bulb socket to maneuver through. These also appear on a few table lamps. You can use a bulb clip on a substitute shade rather than an uno bracket.
Consider placing these basic tips to work on your next rawhide lamp color or substitute lampshade project and you’ll make certain to measure, order and receive the right size lamp colour the very first moment.