hymalayan salt lamps – If you have ever ordered rawhide lamp shades or any sort of lampshade for this matter over the telephone or online, you know it can be a difficult undertaking. It can be very frustrating because different individuals quantify lampshades otherwise.
The whole matter is complicated by phone conversations and net ordering. If you know how you should measure a shade to obtain the proper fit and also communicate the appropriate size, you’ll avoid problems and get the lamp colour you are expecting.
It doesn’t matter if the shade is made from rawhide or not, there are a few suggestions you should know to accurately measure and order a colour and also terminology which can allow you to insure that the person receiving your order is on the same track. Since we encounter this issue constantly we have some hints that we use to assure the appropriate style for a lamp, even without visiting ourselves.
How to quantify:
- You’ll have to have three important dimensions, bottom diameter, high diameter and height. The base diameter is the dimension across the base opening of the lamp shade. The top diameter is the distance over the top opening of the colour. The height of a lampshade ought to be measured up and down vertically, not over the slant. When conveying the dimensions different folks and stores will set the 3 dimensions in different sequence, it’s not standard, so be careful that you are not confusing the underside and height dimensions for example.
- The height ought to be measured down and up, but a few will quantify across the slant. Both of these dimensions can be very different and cause the final shade to be incorrect if confused. Always clarify how the height is measured. We have discovered that many people who quantify the slant of the colour refer to it as the colour’s length rather than height.
Height Measuring Hint:
The reason you need to measure height up and down, vertically, is that the height dimension of your lamp out of bulb socket base to top of harp is probably the minimum vertical height you will want to pay the electrical components with the colour
If you are thinking about a stock replacement colour, your lamp general height and look can be adjusted. The cable harp that retains the shade over the bulb is interchangeable. That is great news if a typical shade is state an inch to brief. Rather than needing to order a custom colour you could alter the harp causing the shade to sit on the lamp to give you the desired look.
Shade Mounting Type:
A standard color bracket has a centre bar across the top with a pit for the harp mount or a washer based by three supports that attach to the top rim of the colour. Both allow the shade to be secured to the harp. Some smaller lamps and chandeliers don’t use a harp but instead use a bulb clip to attach directly to the bulb. A bulb clip is two wire loops which are attached to the shade’s centre bar and grip the bulb.
An bulb clip adapter could be added to any typical shade allowing it to be put over the bulb. Chandelier lamp shades usually have built-in bulb clips created for the small flame or candelabra shaped bulbs. Shades used as hanging lamps can use an uno mount which includes a centre ring large enough for the bulb socket to maneuver through. These also look on a few table lamps. You can use a bulb clip onto a replacement shade rather than an uno mount.
Consider placing these simple suggestions to work on your next rawhide lamp shade or replacement lampshade project and you’ll be sure to measure, order and get the right size lamp colour the first moment.