hand painted lamp shades table lamps

60 views

hand-painted-lamp-shades-table-lamps hand painted lamp shades table lamps

hand painted lamp shades table lamps – In case you have ever purchased rawhide lamp shades or any type of lampshade for that matter over the phone or on the internet, you know it can be a difficult undertaking. It can be very frustrating because different individuals measure lampshades differently.

The entire matter is complicated by telephone conversations and internet ordering. If you understand the best way to measure a shade to get the proper fit and also communicate the appropriate dimensions, you will avoid problems and receive the lamp shade you’re expecting.

It doesn’t matter if the shade is made of rawhide or not, there are a couple of suggestions you should know to accurately measure and order a shade and also terminology which can allow you to insure that the person receiving your order is on the same track. We create custom rawhide lamp shades for rustic western lamps and southwest home decorating. Because we encounter this issue all the time we have some tips that we use to insure the appropriate style for a lamp, even without visiting ourselves.

How to measure:

  1. You’ll have to possess three important measurements, bottom diameter, top diameter and height. The bottom diameter is the measurement across the bottom opening of the lamp shade. The height of a lampshade ought to be measured up and down, not over the slant. This is where the confusion starts. When conveying the measurements different individuals and stores will place the three measurements in different order, it is not normal, so be careful that you’re not confusing the underside and height measurements such as.
  2. The height ought to be measured down and up, but a few will measure along the slant. Both of these measurements are often quite different and cause the final shade to be wrong if perplexed. Always clarify the method by which the height is measured. We’ve discovered that lots of people who measure the slant of this shade refer to it as the colour’s length instead of height.

Height Measuring Tip:

If you’re considering a stock replacement shade, your lamp general height and look can be adjusted. The cable harp that retains the shade within the bulb is synonymous. This is great news if a standard shade is say an inch to short. Rather than having to order a custom shade you could alter the harp causing the shade to sit lower on the lamp to give you the desired look.

A normal shade mount has a centre bar across the top with a hole to the harp mount or a washer centered by three supports that attach to the upper rim of the shade. Both allow the shade to be secured to the harp. Some smaller lamps and chandeliers do not use a harp but rather make use of a bulb clip to attach directly to the bulb. A bulb clip is simply two wire loops which are attached to the color’s centre bar and grip the bulb.

An bulb clip adapter can be added to any standard shade allowing it to be put within the bulb. Chandelier lamp shades normally have built-in bulb clips created for the little flame or candelabra shaped bulbs. Shades used as hanging lamps can use an uno mount which has a centre ring large enough for the bulb socket to maneuver through. These also look on a few table lamps. It’s possible to use a bulb clip on a substitute shade rather than an uno mount.

Consider putting these simple suggestions to work on your next rawhide lamp shade or substitute lampshade project and you will make certain to measure, order and receive the right size lamp shade the first moment.

Leave a reply "hand painted lamp shades table lamps"

Author: 
    author