frosted glass lamp shade replacements – If you have ever purchased rawhide lamp shades or any type of lampshade for this matter over the telephone or online, you are aware that it can be a difficult task. It can be very frustrating because different individuals quantify lampshades differently.
The whole thing is complicated by telephone conversations and internet ordering. If you understand the best way to measure a shade to get the correct fit and communicate the appropriate dimensions, you’ll avoid problems and receive the lamp colour you are expecting.
It doesn’t matter whether the shade is made from rawhide or not, there are a couple of tips you should know to accurately measure and order a colour and also terminology that can allow you to insure that the individual receiving your order is on precisely the same track. Because we encounter this issue constantly we’ve got some hints that we use to assure the appropriate look for a lamp, even without visiting ourselves.
How to quantify:
- You will have to have three important dimensions, bottom diameter, high diameter and height. The bottom diameter is the dimension across the bottom opening of the lamp shade. The elevation of a lampshade ought to be measured up and down vertically, not along the slant. This is where the confusion begins. When communicating the dimensions different individuals and stores will place the 3 measurements in different sequence, it’s not normal, so be careful that you are not confusing the bottom and height dimensions for example.
- The height ought to be measured down and up, but some will quantify across the slant. Both of these dimensions are often very different and cause the finished shade to be incorrect if perplexed. Always clarify the method by which the elevation is measured. We’ve discovered that many people who quantify the slant of the colour refer to it as the colour’s length instead of height.
Height Measuring Hint:
The reason you should measure height up and down, vertically, is that the elevation dimension of your lamp from bulb socket base to top of harp is Most Likely the minimum vertical elevation you will want to cover the electric components with the colour
Height Adjustment Tip:
If you are thinking about a stock replacement colour, your lamp general height and appearance can be adjusted. The cable harp that retains the shade over the bulb is interchangeable. This is great news if a standard shade is state an inch to short. Instead of having to order a personalized colour you could change the harp causing the shade to sit on the lamp to give you the desired appearance.
Shade Mounting Type:
A normal color bracket has a center bar across the top with a hole for the harp bracket or a washer centered by three supports that attach to the top rim of the colour. Both allow the shade to be procured to the harp. Some smaller lamps and chandeliers do not utilize a harp but rather use a bulb clip to attach directly to the bulb. A bulb clip is simply two wire loops that are connected to the shade’s center bar and hold the bulb.
An bulb clip adapter could be added to any standard shade allowing it to be placed over the bulb. Chandelier lamp shades normally have built-in bulb clips made for the small flame or candelabra shaped bulbs. Shades used as hanging lamps can use an uno bracket that has a center ring large enough to get the bulb socket to pass through. These also appear on some table lamps. You can use a bulb clip on a replacement shade instead of an uno bracket.
Consider placing these basic tips to work on your next rawhide lamp shade or replacement lampshade project and you’ll be sure to measure, order and receive the ideal size lamp colour the very first moment.