floor lamp shade replacements – If you’ve ever purchased rawhide lamp shades or any type of lampshade for that matter over the telephone or online, you are aware that it can be a difficult task. It can be quite frustrating because different individuals measure lampshades otherwise.
The whole matter is complicated by phone conversations and net ordering. If you understand the best way to measure a shade to get the correct fit and communicate the correct dimensions, you’ll avoid problems and get the lamp colour you are expecting.
It isn’t important if the shade is made of rawhide or not, there are a few tips you should know to correctly measure and order a colour and additionally vocabulary which can help you insure that the individual receiving your order is on the same track. We create custom made rawhide lamp shades for rustic western lamps and southwest home decorating. Because we encounter this issue constantly we’ve got some hints that we use to assure the correct look for a lamp, even without visiting the lamp ourselves.
How to measure:
- You will need to have three key dimensions, bottom diameter, top diameter and height. The bottom diameter is the dimension across the bottom opening of the lamp shade. The height of a lampshade ought to be measured straight up and down vertically, not over the slant. When communicating the dimensions different individuals and shops will place the 3 dimensions in different sequence, it’s not standard, so be careful that you are not confusing the bottom and height dimensions for example.
- The height ought to be measured straight down and up, but some will measure across the slant. Both of these dimensions can be quite different and induce the finished shade to be wrong if perplexed. Always clarify how the height is measured. We’ve found that many men and women who measure the slant of this colour refer to it because the colour’s length rather than height.
Height Measuring Tip:
The reason you should measure height up and down, vertically, is the height dimension of your lamp from bulb socket foundation to top of harp is probably the minimum vertical height you will want to pay the electrical parts with the colour
If you are thinking about a stock replacement colour, your lamp general height and appearance can be adjusted. The cable harp that holds the shade over the bulb is synonymous. This is great news if a standard shade is state an inch to short. Rather than having to order a personalized colour you could change the harp causing the shade to sit on the lamp to give you the desired appearance.
Shade Mounting Type:
A standard shade mount has a centre bar across the top with a hole to the harp mount or a washer based by three supports that attach to the upper rim of the colour. Both allow the shade to be procured to the harp. Some smaller lamps and chandeliers don’t utilize a harp but instead use a bulb clip to attach directly to the bulb. A bulb clip is two wire loops which are attached to the color’s centre bar and grip the bulb.
An bulb clip adapter could be added to any standard shade allowing it to be placed over the bulb. Chandelier lamp shades normally have built-in bulb clips made for the small flame or candelabra shaped bulbs. Shades used as hanging lamps may use an uno mount which has a centre ring big enough to get the bulb socket to maneuver through. These also appear on some table lamps. It’s possible to use a bulb clip on a substitute shade instead of an uno mount.
Consider putting these basic tips to work on your next rawhide lamp shade or substitute lampshade project and you’ll be sure to measure, order and get the ideal size lamp colour the first time.