decorative cord covers for lamps

83 views

decorative-cord-covers-for-lamps decorative cord covers for lamps

decorative cord covers for lamps – In case you’ve ever ordered rawhide lamp shades or any sort of lampshade for that matter over the phone or on the internet, you are aware that it can be a difficult task. It can be quite frustrating because different individuals measure lampshades differently.

The whole thing is complicated by phone conversations and internet ordering. If you understand how you should measure a shade to get the correct fit and also communicate the correct size, you’ll avoid problems and receive the lamp colour you are expecting.

It isn’t important whether the shade is made of rawhide or not, there are a few tips you should know to correctly measure and purchase a colour and also terminology which can allow you to insure that the individual receiving your purchase is on the same track. Since we experience this issue all the time we have some hints that we use to assure the correct style for a lamp, even without seeing ourselves.

How to measure:

  1. You’ll have to have three important dimensions, bottom diameter, top diameter and height. The bottom diameter is the dimension across the bottom opening of the lamp shade. The top diameter is the distance across the upper opening of the colour. The elevation of a lampshade ought to be measured up and down, not along the slant. When communicating the dimensions different folks and shops will place the three measurements in different order, it’s not normal, so be careful that you are not confusing the bottom and height dimensions such as.
  2. The height ought to be measured down and up, but some will measure across the slant. Both of these dimensions are often very different and induce the finished shade to be incorrect if confused. Always clarify the method by which the elevation is measured. We have found that lots of people who measure the slant of the colour refer to it as the colour’s length instead of height.

Height Measuring Tip:

If you are considering a stock replacement colour, your lamp general height and appearance can be adjusted. The wire harp that holds the shade within the bulb is interchangeable. This is excellent news if a typical shade is state an inch to short. Rather than having to purchase a personalized colour you could alter the harp causing the shade to sit on the lamp to give you the desired appearance.

A normal shade mount has a centre bar across the top with a pit for the harp bracket or a washer centered by three affirms that attach to the upper rim of the colour. Both allow the shade to be secured to the harp. Some smaller lamps and chandeliers do not utilize a harp but rather use a bulb clip to attach directly to the bulb. A bulb clip is simply two wire loops which are attached to the color’s centre bar and hold the bulb.

An bulb clip adapter could be added to any typical shade allowing it to be put within the bulb. Chandelier lamp shades normally have built-in bulb clips made for the small flame or candelabra shaped bulbs. Shades used as hanging lamps can use an uno bracket that has a centre ring large enough to get the bulb socket to pass through. These also look on some table lamps. You can use a bulb clip onto a substitute shade rather than an uno bracket.

Try placing these basic tips to work on your next rawhide lamp shade or substitute lampshade project and you’ll make certain to measure, order and receive the ideal size lamp colour the first time.

Leave a reply "decorative cord covers for lamps"

Author: 
    author