cordless heat lamp


cordless-heat-lamp cordless heat lamp

cordless heat lamp – In case you’ve ever purchased rawhide lamp shades or any sort of lampshade for that matter over the phone or online, you know it can be a challenging task. It can be very frustrating because different individuals measure lampshades differently.

The whole thing is complicated by phone conversations and internet ordering. If you know the best way to measure a color to obtain the correct fit and also communicate the correct dimensions, you’ll avoid problems and get the lamp shade you are expecting.

It isn’t important whether the color is made from rawhide or not, there are a few tips you should know to correctly measure and order a shade and additionally vocabulary that can help you insure that the individual receiving your order is on the same track. We produce custom made rawhide lamp shades for rustic western lamps and southwest home decorating. Since we experience this issue constantly we’ve got some tips that we use to insure the correct style for a lamp, even without seeing the lamp ourselves.

How to measure:

  1. You will need to have three key measurements, bottom diameter, high diameter and height. The bottom diameter is the dimension across the bottom opening of the lamp color. The top diameter is the distance across the upper opening of the shade. The elevation of a lampshade should be measured straight up and down, not over the slant. This is where the confusion begins. When conveying the measurements different folks and stores will place the 3 dimensions in different sequence, it is not standard, so be careful that you are not confusing the underside and height measurements for example.
  2. The height should be measured straight down and up, but a few will measure along the slant. These two measurements are often quite different and cause the finished shade to be incorrect if confused. Always clarify the method by which the elevation is measured. We’ve discovered that many men and women who measure the slant of the shade refer to it because the colour’s length instead of height.

Height Measuring Hint:

If you are considering a stock replacement shade, your lamp general height and look can be corrected. The wire harp that holds the color over the bulb is interchangeable. That is excellent news if a standard shade is state an inch to short. Rather than needing to order a custom shade you could alter the harp causing the color to sit on the lamp to give you the desired look.

A standard color bracket has a centre bar across the top with a pit for the harp bracket or a washer based by three affirms that attach to the upper rim of the shade. Both allow the color to be procured to the harp. A bulb clip is two wire loops that are attached to the color’s centre bar and hold the bulb.

An bulb clip adapter can be added to any standard shade allowing it to be put over the bulb. Chandelier lamp shades usually have built-in ribbon clips made for the little flame or candelabra shaped bulbs. Colors used as hanging lamps may use an uno bracket which includes a centre ring large enough for the bulb socket to pass through. These also appear on a few table lamps. It’s possible to use a bulb clip onto a replacement shade instead of an uno bracket.

Consider placing these basic tips to work on your next rawhide lamp color or replacement lampshade project and you’ll be sure to measure, order and get the ideal size lamp shade the first time.

Leave a reply "cordless heat lamp"