battery powered lava lamp – In case you’ve ever purchased rawhide lamp shades or any type of lampshade for that matter over the phone or on the internet, you know it can be a challenging undertaking. It can be very frustrating because different people measure lampshades otherwise.
The entire thing is complicated by telephone conversations and internet ordering. If you know how you should measure a color to obtain the correct fit and communicate the correct dimensions, you will avoid problems and get the lamp shade you are expecting.
It isn’t important if the color is made from rawhide or not, there are a couple of tips you should know to correctly measure and purchase a shade and also terminology which will allow you to insure that the individual receiving your purchase is on the same track. Since we encounter this issue all the time we have some tips that we use to assure the correct style for a lamp, even without visiting the lamp ourselves.
How to measure:
- You’ll need to possess three key measurements, bottom diameter, high diameter and height. The bottom diameter is the measurement across the bottom opening of the lamp color. The top diameter is the distance across the upper opening of the shade. The elevation of a lampshade ought to be measured straight up and down vertically, not over the slant. This is where the confusion starts. When communicating the measurements different folks and stores will place the three measurements in different order, it’s not standard, so be careful that you are not confusing the bottom and height measurements for example.
- The height ought to be measured straight down and up, but some will measure along the slant. Both of these measurements are often very different and cause the final shade to be wrong if perplexed. Always clarify how the elevation is measured. We’ve discovered that many men and women who measure the slant of the shade refer to it as the shade’s length instead of height.
Height Measuring Hint:
Height Adjustment Tip:
If you are considering a stock replacement shade, your lamp general height and appearance can be corrected. The wire harp that holds the color over the bulb is synonymous. This is excellent news if a standard shade is say an inch to short. Rather than having to purchase a custom shade you could change the harp causing the color to sit on the lamp to offer you the desired appearance.
Shade Mounting Type:
A standard shade mount has a center bar across the top with a pit for the harp bracket or a washer centered by three affirms that attach to the upper rim of the shade. Both allow the color to be secured to the harp. A bulb clip is simply two wire loops which are attached to the color’s center bar and grip the bulb.
An bulb clip adapter can be added to any standard shade to allow it to be put over the bulb. Chandelier lamp shades normally have built-in ribbon clips made for the small flame or candelabra shaped bulbs. Colors used as hanging lamps may use an uno bracket that includes a center ring large enough to get the bulb socket to maneuver through. These also appear on some table lamps. It’s possible to use a bulb clip on a substitute shade instead of an uno bracket.
Try putting these basic tips to work on the following rawhide lamp color or substitute lampshade project and you will be sure to measure, order and get the right size lamp shade the very first moment.