anchorn converter for halogen lamps

47 views

anchorn-converter-for-halogen-lamps anchorn converter for halogen lamps

anchorn converter for halogen lamps – If you have ever ordered rawhide lamp shades or any type of lampshade for that matter over the telephone or online, you know it can be a challenging undertaking. It can be quite frustrating because different people measure lampshades otherwise.

The entire thing is complicated by phone conversations and internet ordering. If you understand the best way to measure a color to get the proper fit and communicate the appropriate size, you’ll avoid problems and get the lamp shade you are expecting.

It isn’t important whether the color is made from rawhide or not, there are a couple of suggestions you should know to accurately measure and purchase a shade and also terminology that can allow you to insure that the individual receiving your purchase is on precisely the same track. We produce custom made rawhide lamp shades for rustic western lamps and southwest home decorating. Because we experience this issue all the time we have some tips that we use to insure the appropriate look for a lamp, even without seeing the lamp ourselves.

How to measure:

  1. You will need to possess three important measurements, bottom diameter, top diameter and height. The base diameter is the dimension across the base opening of the lamp color. The height of a lampshade should be measured up and down vertically, not along the slant. When conveying the measurements different individuals and shops will place the three dimensions in different order, it is not normal, so be careful that you are not confusing the bottom and height measurements for example.
  2. The height should be measured down and up, but a few will measure along the slant. These two measurements are often very different and induce the finished shade to be incorrect if confused. Always clarify the method by which the height is measured. We have discovered that lots of people who measure the slant of this shade refer to it because the shade’s length rather than height.

Height Measuring Tip:

The main reason you should measure height up and down, vertically, is the height dimension of your lamp out of bulb socket base to top of harp is probably the minimum vertical height you will want to pay the electrical parts with the shade

If you are considering a stock replacement shade, your lamp general height and appearance can be adjusted. The wire harp that retains the color over the bulb is synonymous. This is great news if a standard shade is state an inch to brief. Instead of needing to purchase a personalized shade you could alter the harp causing the color to sit on the lamp to give you the desired appearance.

A normal shade mount has a center bar across the top with a pit for the harp mount or a washer based by three supports that attach to the top rim of the shade. Both allow the color to be procured to the harp. Some smaller lamps and chandeliers do not use a harp but instead make use of a bulb clip to attach directly to the bulb. A bulb clip is two wire loops that are attached to the color’s center bar and grip the bulb.

An bulb clip adapter can be inserted to any standard shade to allow it to be put over the bulb. Chandelier lamp shades normally have built-in bulb clips made for the little flame or candelabra shaped bulbs. Colors used as hanging lamps may use an uno mount which has a center ring large enough for the bulb socket to maneuver through. These also look on a few table lamps. It’s possible to use a bulb clip onto a replacement shade rather than an uno mount.

Try placing these simple suggestions to work on the following rawhide lamp color or replacement lampshade project and you’ll be sure to measure, order and get the right size lamp shade the very first time.

Leave a reply "anchorn converter for halogen lamps"

Author: 
    author