15 inch lamp shades – If you’ve ever purchased rawhide lamp shades or any type of lampshade for that matter over the telephone or online, you are aware that it can be a challenging undertaking. It can be quite frustrating because different people measure lampshades otherwise.
The entire matter is complicated by telephone conversations and internet ordering. If you know how you should measure a color to get the proper fit and communicate the appropriate dimensions, you’ll avoid problems and get the lamp shade you are expecting.
It isn’t important if the color is made from rawhide or not, there are a few suggestions you should know to correctly measure and order a shade and also terminology which will help you insure that the individual receiving your order is on precisely the same track. Since we experience this issue all the time we have some tips that we use to insure the appropriate look for a lamp, even without visiting the lamp ourselves.
How to measure:
- You’ll need to have three key measurements, bottom diameter, high diameter and height. The base diameter is the measurement across the base opening of the lamp color. The top diameter is the distance across the upper opening of the shade. The height of a lampshade should be measured up and down vertically, not over the slant. When communicating the measurements different individuals and stores will place the three measurements in different order, it’s not normal, so be careful that you are not confusing the underside and height measurements such as.
- The height should be measured up and down, but a few will measure along the slant. These two measurements are often very different and cause the final shade to be wrong if confused. Always clarify the method by which the height is measured. We have discovered that lots of people who measure the slant of the shade refer to it as the colour’s length instead of height.
Height Measuring Hint:
The reason you should measure height up and down, vertically, is that the height measurement of your lamp out of bulb socket base to top of harp is probably the minimum vertical height you will want to cover the electric components with the shade
Height Adjustment Tip:
If you are considering a stock replacement shade, your lamp’s overall height and look can be adjusted. The cable harp that holds the color over the bulb is synonymous. This is great news if a standard shade is say an inch to short. Instead of having to order a personalized shade you could alter the harp causing the color to sit lower on the lamp to offer you the desired look.
A normal shade mount has a centre bar across the top with a pit for the harp mount or a washer based by three affirms that attach to the upper rim of the shade. Both allow the color to be secured to the harp. Some smaller lamps and chandeliers don’t utilize a harp but rather use a bulb clip to attach directly to the bulb. A bulb clip is two wire loops which are connected to the color’s centre bar and hold the bulb.
An bulb clip adapter can be inserted to any standard shade allowing it to be placed over the bulb. Chandelier lamp shades normally have built-in bulb clips created for the small flame or candelabra shaped bulbs. Shades used as hanging lamps may use an uno mount which has a centre ring big enough to get the bulb socket to maneuver through. These also appear on a few table lamps. It’s possible to use a bulb clip onto a substitute shade rather than an uno mount.
Consider placing these basic suggestions to work on your next rawhide lamp color or substitute lampshade project and you’ll be sure to measure, order and get the right size lamp shade the very first moment.